Tappan Oven/Microwave Combo Parts

Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Overall length is 3.72", amperage range 3.2 to 3.6. The igniter is the most commonly defective part for a gas oven not heating correctly or at all.

OEM Part - Manufacturer #5303935066

Chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.

OEM Part - Manufacturer #316048413

Chrome drip bowl for 6-inch electric coil burner. This drip bowl sits underneath the burner to catch drips or spills.

OEM Part - Manufacturer #316048414

Stove top surface element terminal block kit with interchangeable mounting brackets. The kit also includes ceramic wire nuts, heat shrink protective tubing, and wires. If the element works intermittently then the receptacle may be making poor contact with the element and needs replacement.

OEM Part - Manufacturer #5303935058

Front glide for oven drawer. Requires (2) one for each side. For the rear glides see related parts below.

OEM Part - Manufacturer #3051162

For the rear drawer glide, order part 496.

Rear glide for oven lower storage drawer.

OEM Part - Manufacturer #3051163

The front glide may also need to be replaced.

Appliance light bulbs (2 pack).

-40 Watts
-Frosted

OEM Part - Manufacturer #5304490731

Range/stove surface element control switch repair kit. Compatible with a variety of models. The surface element switch sends voltage to the surface element coil. If the surface element is not heating, first test the surface element. If the element is not defective, the switch is likely at fault.

OEM Part - Manufacturer #5303935086

Oven temperature sensor

OEM Part - Manufacturer #316217002

Watch our “Part Testing” video to determine if the oven sensor is defective or is not functioning properly and needs to be replaced.

Stove top chrome drip pan for 6" burner - Part has been updarted and no longer comes with the clip

OEM Part - Manufacturer #5303935057

Terminal block kit for electric range and dryer power cords.

OEM Part - Manufacturer #5304409888

Oven bottom insulation

OEM Part - Manufacturer #316403803

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

OEM Part - Manufacturer #5304497424

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.