Kelvinator Washer/Dryer Combo Parts

Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.

OEM Part - Manufacturer #5303281153

Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.

OEM Part - Manufacturer #5366021400

Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.

OEM Part - Manufacturer #5303931775

Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced

OEM Part - Manufacturer #134120900

Front upper felt glide pad. Includes nylon glides, adhesive, and installation instructions. These drum glides help to support the front of the dryer drum as it rotates.

OEM Part - Manufacturer #5303937139

Your dryer has two drum glides. Because the drum glides wear out at the same time, we recommend replacing them together.

Rear bearing support cup for dryer drum. If the drum support ball is also worn you can purchase these items in a drum bearing kit. See related item.

OEM Part - Manufacturer #131825900

Dryer heating element and housing assembly. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

OEM Part - Manufacturer #131475320

Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

OEM Part - Manufacturer #5304516871

Washer drive belt. If this belt is broken, the washer will not spin or agitate.

OEM Part - Manufacturer #134511600

The tension pulley may also be worn.

Dryer high-limit thermostat, L260-70F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.

OEM Part - Manufacturer #3204267

Use a multimeter to test your high-limit thermostat for continuity.

Condenser brush

OEM Part - Manufacturer #L304433062

This vacuum cleaner attachment is useful for cleaning condenser coils and dryer venting systems.

Lower felt seal, dryer drum front. See related parts for hi temp adhesive

OEM Part - Manufacturer #5303283286

Washing machine belt tension pulley assembly

OEM Part - Manufacturer #131862900