Gibson GLSE62RHS0 Washer/Dryer Combo Replacement Parts

Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.

OEM Part - Manufacturer #5303281153

Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

OEM Part - Manufacturer #5304516871

Washer drive belt. If this belt is broken, the washer will not spin or agitate.

OEM Part - Manufacturer #134511600

The tension pulley may also be worn.

Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced

OEM Part - Manufacturer #134120900

Door Catch

OEM Part - Manufacturer #131658800

Dryer high-limit thermostat, L260-70F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.

OEM Part - Manufacturer #3204267

Use a multimeter to test your high-limit thermostat for continuity.

Drum felt seal & glides

OEM Part - Manufacturer #5303937139

Your dryer has two drum glides. Because the drum glides wear out at the same time, we recommend replacing them together.

Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.

OEM Part - Manufacturer #137221600

Idler pulley and arm, dryer

OEM Part - Manufacturer #5304507499

Dryer heating element and housing assembly. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

OEM Part - Manufacturer #131475320

Bearing cup for drum support ball

OEM Part - Manufacturer #131825900

The Frigidaire Blower Wheel 131476300 is a high-quality part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. Recommended to use safety equipment. Disconnect the appliance before repair. Consult the owner's manual for instructions.

OEM Part - Manufacturer #131476300

Leveling leg

OEM Part - Manufacturer #134548800