Tappan Range/Stove/Oven Parts

Chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.

OEM Part - Manufacturer #316048413

Surface element control switch for the large surface element

OEM Part - Manufacturer #316436001

Surface element receptacle with wires, wire nuts, and heat-shrink tubing

OEM Part - Manufacturer #5303935058

This is a genuine replacement part. The model number and name for the following item is: Frigidaire 3051162 Drawer Glide.

OEM Part - Manufacturer #3051162

For the rear drawer glide, order part 496.

8 Inch electric coil surface element with looped terminals, 2600 watts. 5 turns

OEM Part - Manufacturer #316442301

The element receptacle (or terminal block) wears out over time. If the surface element is defective, you may want to replace both the surface element and the receptacle.

This is a genuine replacement part. The model number and name for the following item is: Frigidaire 3051163 Drawer Glide.

OEM Part - Manufacturer #3051163

The front glide may also need to be replaced.

Surface element control switch for the small surface element

OEM Part - Manufacturer #316436000

6-inch electric coil surface element with looped terminals, 1250 watt, 4 turn. If the surface element does not have continuity (an unbroken electrical circuit), the surface element won't heat.

OEM Part - Manufacturer #318372211

To determine if the surface element is defective, use a multimeter to test it for continuity.

Chrome drip bowl, 6 inches

OEM Part - Manufacturer #L304430992

Broiler pan and insert

OEM Part - Manufacturer #5304494997

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

OEM Part - Manufacturer #5304497424

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.

Oven bottom insulation

OEM Part - Manufacturer #316403803

Screw,8-18 x 0.5 ,chrome

OEM Part - Manufacturer #316021109