Gibson Range/Stove/Oven Model GEF352BHWB Parts

Chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.

OEM Part - Manufacturer #316048413

Appliance light bulb, clear 120 Volt 40 Watt Regular Base

OEM Part - Manufacturer #316538904

Surface element control switch for the large surface element

OEM Part - Manufacturer #316436001

Surface element receptacle with wires, wire nuts, and heat-shrink tubing

OEM Part - Manufacturer #5303935058

This is a genuine replacement part. The model number and name for the following item is: Frigidaire 3051162 Drawer Glide.

OEM Part - Manufacturer #3051162

For the rear drawer glide, order part 496.

This is a genuine replacement part. The model number and name for the following item is: Frigidaire 3051163 Drawer Glide.

OEM Part - Manufacturer #3051163

The front glide may also need to be replaced.

Surface element control switch for the small surface element

OEM Part - Manufacturer #316436000

Oven anti-tip bracket kit. This bracket helps to secure the range and prevent it from tipping over.

OEM Part - Manufacturer #316112005

Chrome drip bowl, 6 inches

OEM Part - Manufacturer #L304430992

Terminal block for main power supply or cord

OEM Part - Manufacturer #5304409888

Broiler pan and insert

OEM Part - Manufacturer #5304494997

Receptacle,oven light

OEM Part - Manufacturer #316116400

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

OEM Part - Manufacturer #5304497424

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.