Kenmore Range/Stove/Oven Parts

Surface element control switch for the large surface element

OEM Part - Manufacturer #316436001

Surface element receptacle with wires, wire nuts, and heat-shrink tubing

OEM Part - Manufacturer #5303935058

8 Inch electric coil surface element with looped terminals, 2600 watts. 5 turns

OEM Part - Manufacturer #316442301

The element receptacle (or terminal block) wears out over time. If the surface element is defective, you may want to replace both the surface element and the receptacle.

Surface element control switch for the small surface element

OEM Part - Manufacturer #316436000

Terminal block for main power supply or cord

OEM Part - Manufacturer #5304409888

8" porcelain drip pan

OEM Part - Manufacturer #A316222301

Drip pan, 6 inches, black

OEM Part - Manufacturer #A316222201

Broiler pan and insert

OEM Part - Manufacturer #5304494997

Indicator Light

OEM Part - Manufacturer #316022500

Receptacle,oven light

OEM Part - Manufacturer #316116400

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

OEM Part - Manufacturer #5304497424

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.

Lens,indicator light

OEM Part - Manufacturer #318228310

Oven bottom insulation

OEM Part - Manufacturer #316403803