Frigidaire FEF352BAWE Range/Stove/Oven Parts

8 Inch electric coil surface element with looped terminals, 2600 watts. 5 turns

The element receptacle (or terminal block) wears out over time. If the surface element is defective, you may want to replace both the surface element and the receptacle.

6-inch electric coil surface element with looped terminals, 1250 watt, 4 turn, black center cap

To determine if the surface element is defective, use a multimeter to test it for continuity.

Glide,drawer, front

For the rear drawer glide, order part 496.

Appliance light bulbs (2 pack).

-40 Watts
*No longer Frosted

Drip pan, 6 inches, black

8" porcelain drip pan

Drawer glide, rear

The front glide may also need to be replaced.

Terminal block for main power supply or cord

Range/stove surface element control switch repair kit. Compatible with a variety of models. The surface element switch sends voltage to the surface element coil. If the surface element is not heating, first test the surface element. If the element is not defective, the switch is likely at fault.

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.

Screw, 8-18 x 0.5, chrome

Light Socket

Oven bottom insulation